CCTV Not Recording ? It’s frustrating when your CCTV system stops recording—especially when you need it most. Don’t worry. Most issues are simple and can be fixed without calling a technician. Here are 7 easy solutions to get your CCTV recording again.
1. Check Main Power Supply
First, make sure your system is getting proper power that is 12V 3 amp when CCTV not recording.
- Is the DVR/NVR turned ON? Showing a red light in the optical mouse.
- Are all camera lights working?
- Check SMPS (power supply unit) connections
👉 If there’s no power, your CCTV will not record anything.
💾 2. Inspect the Hard Disk (HDD)
Your CCTV stores footage in a hard disk.
- Go to DVR settings → Storage
- Check if HDD status is “Normal” or showing an error on the status bar.
- If it shows “Error” or “Not Detected,” the HDD may be damaged
- Also you may hear a BEEP sound from the DVR; that indicates the hard disk is not working.
👉 Solution: Replace or re-install the hard disk.
⚙️ 3. Check Recording Settings
Sometimes recording is turned OFF by mistake , thats the reason of CCTV Not Recording
- Go to Menu → Record Settings
- Ensure Recording Mode = Continuous / Motion Detection
- Check if all channels are enabled
👉 Many users forget to enable recording after installation.
4. Verify Date & Time Settings
Wrong date/time can stop or confuse recordings.
- Go to System Settings → Date & Time
- Set correct time and timezone
- Many times DVR battery not working properly ,thats why hard disk cannot recording due to date format not perfect.
👉 Incorrect time can cause playback issues or no recording.
📡 5. Check Camera Connection
If cameras are not connected properly:
- No video = No recording
- Check BNC cable / IP camera connection
- Look for “No Signal” message on screen
👉 Fix loose or damaged cables.
🔄 6. Restart the DVR/NVR
A simple restart can fix many issues.
- Turn OFF the DVR
- Wait 1–2 minutes
- Turn it ON again
👉 This refreshes the system and often restores recording.
🧹 7. Format the Hard Disk
If storage is full or corrupted:
- Go to HDD settings
- Select “Format HDD”
⚠️ Warning: This will delete all old footage
👉 Use this only if other solutions don’t work.
🚨 Bonus Tip: Check Motion Detection Settings
If your system records only on motion:
- Make sure motion detection is enabled
- Adjust sensitivity level
👉 Low sensitivity = no recording even if movement happens
✅ Final Thoughts
Most CCTV recording problems are caused by:
- Power issues
- Hard disk failure
- Wrong settings
You can fix them easily using the steps above.
📞 Need Professional Help?
If your CCTV still isn’t recording, it might be a hardware issue. In that case, contact a local CCTV technician for inspection , call Siriti techno Lab -9830059942